OKIDATA OL400e Series, Service Manual

Page: 240 / 397

Page: 153
Service Manual for OL400e/OL410e/OL410e-PS
Chapter 3 Maintenance & Disassembly
Print Start Position
General Information
This procedure sets the print start position.
The print start position is the distance from the leading edge of the paper where
printing can begin. Print start positions can vary between printers.
The default is 0.
Negative values of the print start positions move the position closer to the leading
edge of the paper.
Positive values of the print start positions move the position away from the leading
edge of the paper.
Procedure
To modify the print start position, perform the following procedure.
- Close the stacker cover.
- Install the paper cassette tray.
- Clear all error messages displayed on the operator panel.
- Power OFF the unit.
- Press and hold ENTER / Copies and FORM FEED / Tray Select while powering
ON the unit.
- Continue to hold ENTER / COPIES and FORM FEED / Tray Select through all panel
displays.
The operator panel displays the following message for approximately two seconds.
88888888
88888888
The operator panel will briefly display the following message.
INITIAL-
IZING
- Continue to hold ENTER / COPIES and FORM FEED / Tray Select until the operator panel
displays the following message.
ENG MNT
- Press MENU 1 / Menu 2.
The operator panel displays the following message.
LED HEAD
NO.16 *
- Press MENU 1 / Menu 2.
The operator panel displays the following message.