OKIDATA OL400e Series, Service Manual

Page: 219 / 397

Page: 142
Service Manual for OL400e/OL410e/OL410e-PS
Chapter 3 Maintenance & Disassembly
X Adjust
General Information
This function sets the horizontal position of the first printable area (print start position).
Changes are written to the EEPROM.
The print start position is the distance from the leading edge of the paper where printing
can begin. Print start positions can vary between printers.
The default is 0.
Negative values of the print start positions move the position closer to the leading
edge of the paper.
Positive values of the print start positions move the position away from the leading
edge of the paper.
Procedure
To enable or disable the operator menu, perform the following procedure.
- Close the stacker cover.
- Install the paper cassette tray.
- Clear all error messages displayed on the operator panel.
- Power OFF the unit.
- Press and hold MENU 1 / Menu 2 while powering ON the unit.
- The operator panel displays the following for approximately two seconds.
88888888
88888888
- Release MENU 1 / Menu 2 once the operator panel displays the following message.
USER MNT
- Press MENU 1 / Menu 2.
The operator panel displays the following message.
MENU
RESET
- Press MENU 1 / Menu 2.
The operator panel displays the following message.
HEX DUMP