Chapter 4 Memory
MC9S08QL8 MCU Series Reference Manual, Rev. 1
NXP Semiconductors
39
4.3
Register Addresses and Bit Assignments
The registers in the MC9S08QL8 series are divided into these groups:
•
Direct-page registers are the ones located in the first 96 locations in the memory map; these are
accessible with efficient direct addressing mode instructions.
•
High-page registers are used much less often, so they are located above 0x1800 in the memory
map. This leaves more room in the direct page for more frequently used registers and RAM.
•
The nonvolatile register area consists of a block of 16 locations in flash memory at 0xFFB0–
0xFFBF. Nonvolatile register locations include:
— NVPROT and NVOPT are loaded into working registers at reset
— An 8-byte backdoor comparison key that optionally allows a user to gain controlled access to
secure memory
Because the nonvolatile register locations are flash memory, they must be erased and programmed
like other flash memory locations.
Direct-page registers can be accessed with efficient direct addressing mode instructions. Bit manipulation
instructions can be used to access any bit in any direct-page register.
is a summary of all
user-accessible direct-page registers and control bits.
The direct-page registers in
can use the more efficient direct addressing mode, which requires
only the lower byte of the address. Because of this, the lower byte of the address in column one is shown
in bold text. In
, the whole address in column one is shown in bold. In
, and
, the register names in column two are shown in bold to set them apart from the
bit names to the right. Cells that are not associated with named bits are shaded. A shaded cell with a 0
indicates this unused bit always reads as a 0. Shaded cells with dashes indicate unused or reserved bit
locations that could read as 1s or 0s. When writing to these bits, write a 0 unless otherwise specified.
Summary of Contents for MC9S08QL4
