▪
Dual
: You can choose a color for the On state and another color for the Off state. Both col-
ors will be used at full brightness. The
Color On
and
Color Off
menus allow you to choose
both colors from color pickers.
▪
HSB
: This mode is only available when the
LED On
menu is set to
For MIDI In
, i.e. when
the element’s state is controlled via MIDI feedback (see above). In HSB mode you can set
the color from within your MIDI target by sending three MIDI values for hue, brightness,
and saturation, respectively. See below for more info.
▪
Indexed
: This mode is only available when the
LED On
menu is set to
For MIDI In
, i.e.
when the element’s state is controlled via MIDI feedback (see above). In Indexed mode you
can set the color from within your MIDI target by sending a single MIDI value for the color
index. See below for more info.
HSB Mode
HSB mode is not available on the MASCHINE JAM controller. To control the element
color from the MIDI target, please use Indexed mode instead (see below).
HSB mode allows you to remotely set the hue, brightness, and saturation levels of the ele-
ment’s LED via MIDI messages with the same type as the element. The MIDI channel used to
transmit those messages will determine their intent. For example, for a pad assigned to MIDI
CC 9, you could:
▪
Send the CC 9 value 127 on channel 3 to set the pad to full brightness.
▪
Send the CC 9 value 16 on channel 1 to set the pad’s color to yellow.
When using several devices of the same type simultaneously, you can set the elements’ colors
on each particular device by using the MIDI channels listed in the following table:
Reference
MIDI Message Parameters
CONTROLLER EDITOR - Manual - 318
Summary of Contents for komplete kontrol s series
Page 1: ......
