Operating Procedures
0112-0127 B
67
Starting Up the System
Normally, you do not need to switch off power at the end of the day. If
the system will not be used for more than a day, it is best to turn off the
instrument. Use the following procedure only if the system has been
switched off.
1.
Locate the power switch on the back of the instrument.
Figure 3-1:
Power Switch Location
2.
Press the rocker switch to the
ON
position (I).
The instrument automatically performs diagnostic checks to
ensure that it is functioning correctly. All three drawers open and
close. After about four minutes, the control panel displays the
temperature inside the reading chamber. The reading chamber
drawer automatically opens.
Note:
These instructions assume that the SoftMax Pro Software has
been installed and you are ready to begin an experiment. For software
installation instructions, see the SoftMax Pro Software User Guide.
FlexStation_manual.book Page 67 Tuesday, June 25, 2013 10:22 AM
