Maintenance
0112-0127 B
125
4.
Use a 9/64 inch hex key to loosen the clamp screw, located on the
lamp mounting block and facing the rear of the instrument.
Leave the clamp screw in place.
5.
Use a 5/32 inch hex key to loosen the two vertical-mounting cap
screws that are holding the Litepac mounting block to the
baseplate. They are located toward the inside of the lamp’s
mounting box. The two cap screws are spring-loaded and stay in
a raised position so that you can slide out the entire Litepac
without getting the screws caught in the holes.
Figure 4-9:
Removing Litepac Mounting Block Screws
6.
Open the top cover of the instrument to provide better access
and clearance to the lamp’s mounting box. This makes it easier to
remove the lamp assembly.
Note:
You might need a flashlight to see the cap screws.
FlexStation_manual.book Page 125 Tuesday, June 25, 2013 10:22 AM
