Mindray VS-900, Operator'S Manual

Page: 37 / 192

3-5
WARNING

Do not use the monitor on a patient if you suspect it is not working properly, or
if it is mechanically damaged. Contact your service personnel or us.

Check that visual and auditory alarm signals are presented correctly when the
equipment is powered on. Do not use the equipment for any monitoring
procedure on a patient if you suspect it is not working properly, or if it is
mechanically damaged. Contact your service personnel or Mindray.
NOTE

Carefully check if the system performs the self-test as described above. Contact
your service personnel or us if the self-test is abnormal.
3.3.3 Turning off the Monitor
Before turning off the monitor:
1. Confirm that the monitoring is finished.
2. Disconnect patient cables and sensors from the patient.
3. Make sure to save or clear the patient monitoring data as required.
Press and hold the power on/off switch for above 2 seconds to turn off monitor.
CAUTION

Although not recommended, you can press and hold the power on/off switch
for 10 seconds to forcibly shut down the monitor when it could not be shut
down normally or under some special situations. This may cause data loss of the
monitor.

The monitor restores the latest configuration if restarts within 60 seconds after
the power failure. And it will restore the default configuration rather than the
latest configuration if restarts 120 seconds later after the power failure. The
monitor may load either the latest configuration or the default configuration if
restarts from 60-120 seconds after the power failure.

Power failure may cause data damage on SD card. It is recommended to turn off
the monitor according to the normal procedures. Do not directly unplug the
power cord
,
unless there is a charged battery installed, or remove the battery
before shutting down the monitor.