Mindray VS-900, Operator'S Manual

Page: 122 / 192

14-4
2. Select [ Network>> ]
→ [
NTP Setup>> ].
3. Select [ NTP Setup>> ] to enter the NTP Setup menu. Set the following properties:

Set IP address and port.

Set the interval.

Set the time zone.

Switch on/off the daylight saving time.
4. Select [ Ok ] to exit the menu.
To manually start one time synchronization with the NTP server, follow this procedure:
1. Select [ Main ]
→
[ Maintenance >> ]
→
[ User Settings >> ]
→
Enter the required
password
→
Select [ Ok ] to access User Settings menu.
2. Select [ Network>> ]
→ [
NTP Setup>> ]
→ [
Manual
]
.
14.3.4 Realtime Date Send Interval (for HL7 only)
The monitor will send out the monitored parameter data at the set intervals.
1. Select [ Main ]
→
[ Maintenance >> ]
→
[ User Settings >> ]
→
Enter the required
password
→
Select [ Ok ] to access User Settings Menu.
2. Select [ Network>> ]
→ [
EMR Communication>>
].
3. Set [ Real Data Send ] to an appropriate setting.
14.3.5 Alarm Server Setup (for HL7 only)
1. Select [ Main ]
→
[ Maintenance >> ]
→
[ User Settings >> ]
→
Enter the required
password
→
Select [ Ok ] to access User Settings menu.
2. Select [ Network>> ]
→
[ Alarm Server Setup ].
3. Set the IP address and port.
4. Select [ Ok ] to exit the menu.
14.4 Connecting the monitor to the CMS
To connect the monitor to the CMS, proceed as follows:
1 Select [ Main ]
→
[ Maintenance >> ]
→
[ User Settings >> ]
→
enter the required
password
→
Select [ Ok ]
→
[ Network >> ]
→
[ Monitor Network Setup >> ].
2. Set [ Network Type ] and [ Address Type ].
3. Input the monitor IP address, subnet mask and gateway address if the [ Address Type ]
is set to [ Manual ]
4. Connect the monitor to the CMS through either of the following methods: