Analog Outputs C4 Submenu
106
Analog Outputs C4 Submenu
ANALOG OUTPUT 1
(Analog Outputs 1)
Default: SPEED REF
This parameter defines the function of the
analog output #1.
NOTE: The
current
setting of each parameter
is displayed in all caps; all other choices in the
list are displayed in lower case.
ANALOG OUTPUT 2
(Analog Outputs 2)
Default: SPEED FEEDBACK
This parameter defines the function of the
analog output #2.
NOTE: The
current
setting of each parameter
is displayed in all caps; all other choices in the
list are displayed in lower case.
Parameter
[Alphanumeric]
Description
Default
Hidden
item
Run
lockout
ENGLISH (U3)
METRIC (U3)
Analog Output 1
[C401]
analog output #1
SPEED REF
SPEED COMMAND
Y
N
Analog Output 2
[C402]
analog output #2
SPEED FEEDBACK
Y
N
choices…
choice descriptions…
D/A units…
abs pos bin
[1]
(Absolute Position Binary) Raw absolute position reading from the
absolute encoder.
Counts
aux torq cmd
[2]
(Auxiliary Torque Command) Additional torque command from
auxiliary source, when used.
% rated torque
bus voltage
[3]
(DC Bus Voltage Output) Measured DC bus voltage.
% of peak in
current out
[4]
(Current Output) Percent motor current.
% rated current
d-current ref
[5]
(D-Axis Current Reference) D-Axis current component that does not
contribute to torque production and is generally kept at zero. It will be
non-zero at no-load and flux-weakening.
%
drv overload
[6]
(Drive Overload) Percent of drive overload trip level reached.
% of trip point
flux current
[7]
(Flux Producing Current) Measured flux producing current.
% rated current
flux output
[8]
(Flux Output) Measured flux output.
% rated flux
flux ref
[9]
(Flux Reference) Flux reference used by vector control
% rated flux
flux voltage
[10]
(Flux Producing Voltage) Flux producing voltage reference.
% rated volts
frequency out
[11]
(Frequency Output) Electrical frequency.
% rated freq
mtr overload
[12]
(Motor Overload) Percent of motor overload trip level reached.
% of trip point
no function
[13]
(No Function) This setting indicates that the analog output will not
change state for any operating condition; i.e. the output signal will be
constantly false.
None
power output
[14]
(Power Output) Calculated power output.
% rated power
pretorque ref
[15]
(PreTorque Reference) Pre-torque reference.
% base torque
probe 1
[16]
(Probe 1) Programmable setting to be used with conjuction with U7
HEX MONITOR to monitor internal software variables.
probe 2
[17]
(Probe 2) Programmable setting to be used with conjuction with U7
HEX MONITOR to monitor internal software variables.
slip frequency
[18]
(Motor Slip Frequency) Commanded slip frequency.
% rated
frequency
