Lingenfelter NCC-001, Installation And Operating Instructions Manual

Page: 82 / 171

Lingenfelter NCC-001 Nitrous Control Center Installation and Operating Instructions 81
Access from the Computer Program:
From the Status screen , select the stage by pressing either the "Nitrous1" button or the "Nitrous2" button. The
"Pulse Frequency" setting is found in the "Stage Solenoid Pulse Freuency" dialog box under the "Options" Tab.
Click on one of the settings in the scroll-down menu to select the desired pulse frequency setting.
See Appendix B: Nitrous & Fuel Operation for more information.
6.11 Resume Start Percentage
This setting determines the percent at which the Nitrous resumes if the user has to lift the throttle after the nitrous
system is active. This setting is only valid if the Hold And Wait option is ON. This setting is used with the Resume
Percent Per Pulse setting to build a Resume Ramp. If the Resume Start Percent is greater than the current
Nitrous percent, the Resume Ramp is ignored.
Valid Range is 10% to 100% in 1% increments. A setting of 100% disables this feature (no ramp / instant ON).
Access from the Controller:
From the Main screen , select the stage by pressing either the "N2O-1" button or the "N2O-2" button. Press the
“DOWN” arrow button repeatedly until the "Resume Start Percent" menu selection is highlighted and then press
the “ENTER” button. Using the “LEFT” and ”RIGHT” arrow buttons adjust the setting. Press the “SAVE” button to
accept the new setting or press the “ESC” button to exit with no change.
Access from the Computer Program:
From the Status screen , select the stage by pressing either the "Nitrous1" button or the "Nitrous2" button. The
"Nitrous Resume %" setting is found in the "Nitrous Resume Ramp" dialog box under the "Options" Tab. Click
the "UP" and "DOWN" arrow buttons or type in any numeric value in the valid ranges shown above.
See Appendix B: Nitrous & Fuel Operation for more information.