Lingenfelter NCC-001, Installation And Operating Instructions Manual

Page: 125 / 171

Setup Menu 124
Access from the Computer Program:
From the Status screen , press the "SETUP" button. The "Hall Input Pull-Up Resistor Enable" option is found
under the "Hall Input" tab. Click "ON" to enable the Hall Pull-Up resistor feature or "OFF" to disable the feature.
7.12 Fuel PSI Menu
The following options are found in the Fuel PSI Menu, which can be accessed by the "SETUP" button on the main
screen or by clicking the Fuel Sensor tab in the Setup menu of the computer software. The fuel pressure menu
allows the user to data log the fuel pressure in order to disable nitrous when necessary based on the observed fuel
pressure. By having fuel pressure input into the NCC-001, you can also use the relay outputs to trigger an
auxiliary fuel pump based on the desired fuel pressure.
Default Sensor Setup Option
Use this to configure the controller to select the sensor calibration curve. There are two (2) standard sensors
available from LPE, both of which are pre-loaded into the NCC-001 firmware. If you don't plan to use one of the
LPE sensors, you can manually enter the calibration points. Whatever fuel pressure sensors are chosen for the
application, they MUST be 0-5 volt linear output sensors.
Access from the Controller:
From the Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Fuel PSI
Menu is highlighted and then press the “ENTER” button. Press the "ENTER" button to select the "Default Sensor
Setup" option, then the “UP” or “DOWN” button to change the current selection. If the “BACK” button is pressed
no change will be made.
As shown in the screen shot below, the default fuel pressure sensors are:
L480250015: 0-15 PSI sensor
L480260150: 0-150 PSI sensor
Access from the Computer Program: