Lingenfelter NCC-001, Installation And Operating Instructions Manual

Page: 81 / 171

Nitrous Menus: Nitrous1 (N2O-1) and Nitrous2 (N2O-2) 80
Access from the Controller:
From the Main screen , select the stage by pressing either the "N2O_1” button or the "N2O-2" button. Press the
“DOWN” arrow button repeatedly until the "Nitrous Gear Pos" setting is highlighted and then press the “ENTER”
button. Using the “LEFT” and ”RIGHT” arrow buttons adjust the setting. Press the “SAVE” button to accept the
new setting or press the “ESC” button to exit with no change.
Access from the Computer Program:
From the Status screen , select the stage by pressing either the "Nitrous1" button or the "Nitrous2" button. The
"Gear Position" setting is found in the "Nitrous Start Gear Position" dialog box under the "Options" Tab. Click the
"UP" and "DOWN" arrow buttons or type in any numeric value in the valid ranges shown above.
See Appendix B: Nitrous & Fuel Operation for more information.
6.10 Pulse Frequency
This setting determines the number of times per second that the solenoids pulse. A lower setting generally will
provide a more linear power delivery, as well as allow for lower starting percentages to be used. A higher pulse
frequency results in more solenoid pulses per second, which is displayed in the graph setup of the Nitrous Control
Center software by more data points. The correct setup will be different depending on the type of solenoids and
bottle pressure used. Testing is the only way to determine the best frequency for each application. This setting
applies to the respective nitrous and fuel solenoids of for each stage.
NOTE —When changing the pulse frequency the current Nitrous Setup will be time altered. Be sure to
check the Nitrous and Fuel Settings after a Frequency change!
Access from the Controller:
From the Main screen , select the stage by pressing either the "N2O-1" button or the "N2O-2" button. Press the
“DOWN” arrow button to highlight the Pulse Frequency menu selection and then press the “ENTER” button. Using
the “UP” and ”DOWN” buttons selected the desired Pulse Frequency setting. Press “ENTER” to select the new
setting or press “BACK” to exit with no change.