Lingenfelter NCC-001, Installation And Operating Instructions Manual

Page: 62 / 171

Lingenfelter NCC-001 Nitrous Control Center Installation and Operating Instructions 61
NOTE —If this option is "OFF" the progressive system and all timers will reset each time any of the arming criteria
are removed.
Access from the Controller:
From the Main screen , press the “GLOBAL” button. Press the “DOWN” arrow button repeatedly until the "Hold &
Wait" menu selection is highlighted and then press the “ENTER” button. Press the “YES” or “NO” button to
change the current selection. If the “NO” button is pressed, no change will be made.
NOTE —When asked to make a selection from a “Message Box” the default selection will be chosen after 20
seconds.
Access from the Computer Program:
From the Status screen , press the "SETUP" button. The "Hold & Wait" option is found in the "Nitrous Timer
Options" dialog box under the "Options" Tab. Click "ON" to enable the Hold & Wait feature or "OFF" to disable
the feature.
5.4 Main Timer
This setting controls the main timeout period in seconds. This controls the total time elapsed before a system
timeout occurs. The Main Timer acts as a safety feature by limiting the total amount of time the solenoids can be
on once the system is activated.
When the Hold & Wait option is selected, the timer will continue to count down, even after the activation criteria
have been removed. When the Hold & Wait option is not selected and the activation criteria have been removed,
the Main timer will reset and start over when the activation criteria are again met.
Access from the Controller:
From the Main screen press the “SETUP” button, press the “DOWN” arrow button repeatedly until the "Main
Timer" menu selection is highlighted and then press the “ENTER” button. Using the “LEFT” and ”RIGHT” arrow
buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit
with no change.