Lingenfelter NCC-001, Installation And Operating Instructions Manual

Page: 135 / 171

Setup Menu 134
numeric value in the valid ranges shown above.
7.14 Data Log Menu
The following options are found in the Data Log Menu, which can be accessed by the "SETUP" button on the main
screen or by clicking the Options tab in the Data menu of the computer software. The settings in this menu allow
the controller to log data only after the criteria in the following sub-sections are satisfied. The data log enable
parameters are any parameters that, along with the arming input, allow the controller to log data. If no data log
enable parameters are selected, the controller will start the data log when the arming switch is activated. Once the
data log is activated, the logging of data will continue even if the data log enable parameters fall below their
present settings.
Clutch Enable Option
Enabling the Clutch Enable Option allows the NCC-001 to log data when the clutch is released after the arming
switch and clutch pedal are engaged. In other words, data logging is disabled while the clutch pedal is depressed.
When the clutch pedal is released, the data logging feature is enabled. In order to prevent the data log from
beginning prematurely, the arming switch should be enabled after the clutch is engaged. Note: This option applies
to the Clutch Input signal and not the CPP Sensor on Analog1.
Example - You have already staged and are at the starting line ready to launch. Depress the clutch, engage the
arming switch, and the data log feature will engage when the clutch is released.
Access from the Controller:
From the Main screen press the “SETUP” button, press the “DOWN” arrow button repeatedly until the Data Log
Menu is highlighted and then press the “ENTER” button. Press the "ENTER" button to select the "Clutch Enable"
option, then the “YES” or “NO” button to change the current selection. If the “NO” button is pressed no change will
be made.
Access from the Computer Program:
From the Status screen , press the "Data" button. The "Clutch Input" option is found in the "Data Log Enable
Parameters" dialog box under the "Options" Tab.