Lingenfelter NCC-001, Installation And Operating Instructions Manual

Page: 92 / 171

Lingenfelter NCC-001 Nitrous Control Center Installation and Operating Instructions 91
Timer Hold
This setting determines if the +12V Timer Output remains On when the Arming signal is removed and the Hold &
Wait option is also on.
Access from the Controller:
From the Main screen press the “SETUP” button, press the “DOWN” until the Timer Hold menu selection is
highlighted and then press the “ENTER” button. Press the “YES” or “NO” button to change the current selection. If
the “NO” button is pressed no change will be made.
NOTE —When asked to make a selection from a “Message Box” the default selection will be chosen after 20
seconds.
Access from the Computer Program:
From the Status screen , press the "Timer" button. The "Time Hold" option is found in the "Timer Output Hold"
dialog box under the "Options" Tab. Click "ON" to enable the Timer Hold feature or "OFF" to disable the Timer
Hold feature.
Timer Delay
This setting controls the amount of Delay before the +12V Timer Output turns on after the nitrous system is
activated.
If a setting of 0.000 is entered the Timer Output will turn ON with the First Pulse of the Nitrous Solenoid. This
output can NOT be disabled and the user must remove any wires connected to the Output terminal to disable any
device connected.
The valid range is 0.000 to 9.990 in .01 second increments.
Access from the Controller:
From the Main screen press the “SETUP” button and then press the “ENTER” button. Press the "DOWN" button
continuously until the "Timer Setup Menu" is selected, then press "ENTER". Press the "DOWN" button
continuously until the "Timer Delay" setting is highlighted, then press "ENTER". Using the “LEFT” and ”RIGHT”
arrow buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to
exit with no change.