Lingenfelter NCC-001, Installation And Operating Instructions Manual

Page: 124 / 171

Lingenfelter NCC-001 Nitrous Control Center Installation and Operating Instructions 123
Access from the Controller:
From the Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Hall Input
Menu selection is highlighted, and then press the “ENTER” button twice. Press the "DOWN" arrow button until the
either the "Manual Pulse Per Mile" selection is highlighted and then press the "ENTER" button. Use the “LEFT”
and ”RIGHT” arrow buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the
“ESC” button to exit with no change.
Access from the Computer Program:
From the Status screen , press the "SETUP" button. The "Pulse Per Mile" setting is found in the "MPH Setup"
dialog box under the "Hall Input" Tab. Click the "UP" and "DOWN" arrow buttons or type in any numeric value in
the valid ranges shown above.
Hall Pull-Up Option
This option enables or disables a 4.7k Ohm pull-up resistor to +12V on the Hall Input terminal. This option is
normally used when connecting to the vehicle speed signal output from an ECM that is not connected to any other
systems or modules in the vehicle. On vehicles that already have this signal connected, a Pull-Up resistor is
normally already in the circuit. You DO NOT want to have multiple Pull-Up resistors in the circuit.
Access from the Controller:
From the Main screen press the “SETUP” button, press the “DOWN” arrow button repeatedly until the Hall Input
Menu is highlighted and then press the “ENTER” button. Press the "ENTER" button to select the "Hall Pull-up"
option, then the “YES” or “NO” button to change the current selection. If the “NO” button is pressed no change will
be made.