Lingenfelter NCC-001, Installation And Operating Instructions Manual

Page: 100 / 171

Lingenfelter NCC-001 Nitrous Control Center Installation and Operating Instructions 99
Access from the Controller:
From the Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the TPS
Setup Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "Manual
Set Min Volts" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow
buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit
with no change.
Access from the Computer Program:
From the Status screen , press the "Setup" button. The "Closed Throttle Voltage" setting is found in the "TPS
Input Setup" dialog box under the "TPS Input" Tab. Click the "UP" and "DOWN" arrow buttons or type in any
numeric value in the valid ranges shown above.
Manually Set Maximum Wide Open Throttle TPS Voltage
This setting allows the user to manually select the voltage with the Throttle Position Sensor in the wide open
position.
The Valid Range is 0.00 to 5.00 volts in 0.01 volt increments.
Access from the Controller:
From the Main screen, press the “SETUP” button, press the “DOWN” arrow button repeatedly until the TPS Setup
Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "Manual Set
Max Volts" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow
buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit
with no change.
Access from the Computer Program:
From the Status screen , press the "Setup" button. The "TPS WOT Voltage" setting is found in the "TPS Input
Setup" dialog box under the "TPS Input" Tab. Click the "UP" and "DOWN" arrow buttons or type in any numeric