Lingenfelter NCC-001, Installation And Operating Instructions Manual

Page: 144 / 171

Lingenfelter NCC-001 Nitrous Control Center Installation and Operating Instructions 143
From the Status screen , click on the "Save User Program File" button in the toolbar on the upper left-hand side
of the window, as shown below.
NOTE: If you have made changes to the current program and have not saved them, you will be prompted to save
the current program.
Load User Program from Controller
This option allows the user to upload a user program file from the controller so that it can be further modified or
backed up. This feature is very important as the memory on the controller is only capable of holding three (3)
programs at a time. All other user programs must be backed up by using the Nitrous Control Center software. If
the controller already has three existing user programs and the user attempts to flash a fourth user program to the
controller, the new program will replace one of the three user programs already on the controller, which means that
the program that was replaced is erased out of the controller's memory. The only way to retrieve and reuse the
program is if the program was backed up on the computer.
Access from the Computer Program:
There are three (3) ways to load a user program from the controller, denoted below by the bullet points.
Press Ctrl+Alt+O
From the
Status screen , click on the File button in the upper left-hand corner of the window, then click on the
"Load User Program from Controller" button.