Lingenfelter NCC-001, Installation And Operating Instructions Manual

Page: 105 / 171

Setup Menu 104
Access from the Computer Program:
From the Status screen , press the "SETUP" button. The "Clutch Pedal Depressed Voltage" setting is found in the
"Analog Clutch Setup" dialog box under the "Analog1" Tab. Click the "UP" and "DOWN" arrow buttons or type in
any numeric value in the valid ranges shown above.
7.7 Analog2 Setup Menu
There is currently one setting, Data Log Erase Option, available in the Analog2 Setup Menu.
Activating the Data Log Erase Option allows the Data Log memory to be Erased/Activated by applying a +5V
to +12V signal to the Analog2 Input. This option allows you to put a user controlled switch in the vehicle to
manually erase the data log.
Access from the Controller:
From the Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Analog2
Setup Menu selection is highlighted and then press the “ENTER” button. Once in the Analog2 Setup menu, press
the "ENTER" button to select the Erase option. Press the “YES” or “NO” button to change the current selection. If
the “NO” button is pressed no change will be made.
Access from the Computer Program:
From the Status screen , press the "SETUP" button. The "Data Log Erase Enable" option is found in the "Analog2
Config" dialog box under the "Analog2" Tab. Check the box to enable the Data Log Erase Option or un-check the
box to disable the option.