Lingenfelter NCC-001, Installation And Operating Instructions Manual

Page: 130 / 171

Lingenfelter NCC-001 Nitrous Control Center Installation and Operating Instructions 129
any numeric value in the valid ranges shown above.
Fuel PSI Nitrous Disable Delay
This setting controls the amount of time the Fuel Pressure must be below the Fuel PSI disable setting before
disabling the nitrous system.
The Valid Range is 0.000 to 1.000 Seconds in .01 Second increments.
Access from the Controller:
From the Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Fuel PSI
Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "Fuel Disable
Delay" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow buttons
adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit with no
change.
Access from the Computer Program:
From the Status screen , press the "Setup" button. The "Fuel PSI Disable Delay" setting is found in the "Fuel PSI
Disable Setup" dialog box under the "Fuel Sensor" Tab. Click the "UP" and "DOWN" arrow buttons or type in any
numeric value in the valid ranges shown above.
Fuel PSI Nitrous Disable Percentage
This setting allows the user to tell the the controller to only disable the nitrous using the fuel pressure disable
option if the nitrous is ramped up above the set percentage.
For example- If the Fuel PSI disable percentage setting is set to 60%, the nitrous cannot be disabled by the Fuel
PSI option until the nitrous is ramped above 60%, even if the fuel pressure is below the Fuel PSI nitrous disable