Lingenfelter NCC-001, Installation And Operating Instructions Manual

Page: 97 / 171

Setup Menu 96
not the same. While the NCC-001 can accept either signal, LPE recommends that the NCC-001 be connected to
the TPS in most cases.
See Appendix D: Glossary of Terms for more information on the Throttle Position Sensor.
TPS Activation Option
The TPS Activation Option allows the throttle position sensor input to control system activation. The Arming Input
must be used even if this option is selected.
Access from the Controller:
From the Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the TPS Setup
Menu selection is highlighted and then press the “ENTER” button. Press the "ENTER" button to select the TPS
Arming Option, then the “YES” or “NO” button to change the current selection. If the “NO” button is pressed no
change will be made.
Access from the Computer Program:
From the Status screen , press the "SETUP" button. The "TPS Activation Enable" option is found under the "TPS
Input" Tab. Click "ON" to enable the TPS Activation Enable feature or "OFF" to disable the feature.
Activation Percentage
The TPS Activation Percentage setting determines the TPS percent at which system activation will occur based
on TPS alone (other activating criteria must also be met).
The Valid Range is 10% to 100% in 0.1% increments.
Access from the Controller:
From the Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the TPS
Setup Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the
"Activation%" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow
buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit
with no change.