Lingenfelter NCC-001, Installation And Operating Instructions Manual

Page: 131 / 171

Setup Menu 130
setting.
The Valid Range is 0% to 100% in 1% increments.
Access from the Controller:
From the Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Fuel PSI
Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "Fuel Disable
%" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow buttons adjust
the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit with no change.
Access from the Computer Program:
From the Status screen , press the "Setup" button. The "Fuel PSI Disable Percent" setting is found in the "Fuel
PSI Disable Setup" dialog box under the "Fuel Sensor" Tab. Click the "UP" and "DOWN" arrow buttons or type in
any numeric value in the valid ranges shown above.
7.13 Nitrous PSI Menu
The following options are found in the Nitrous PSI Menu, which can be accessed by the "SETUP" button on the
main screen or by clicking the Nitrous Sensor tab in the Setup menu of the computer software. This menu allows
the user to data log the nitrous pressure. Having this sensor in the system allows you to perform closed loop
bottle heater control using one of the NCC-001 relay outputs.
Default Sensor Setup
Use this setting to configure the controller to use the default nitrous pressure sensor. If you are not using the
default LPE 0-2000 PSI nitrous pressure sensor (PN: 480272000), the chosen sensor for the application MUST be
a 0-5 volt linear output sensor.
Access from the Controller:
From the Main screen press the “SETUP” button, press the “DOWN” arrow button repeatedly until the Nitrous PSI
Menu is highlighted and then press the “ENTER” button. Press the "ENTER" button to select the "Default Sensor
Setup" option, then the “YES” or “NO” button to change the current selection. If the “NO” button is pressed no
change will be made.