Lenovo x3250 m6, Installation And Service Manual

Page: 147 / 696

Step 2. Disconnect the power cord from the hot-swap power supply.
Step 3. Press the release tab toward the handle and carefully pull the handle at the same time to slide
the hot-swap power supply out of the chassis.
Figure 68. Hot-swap power supply removal
Step 4. Install the power-supply filler or a new power supply to cover the power supply bay. See “Installing
a hot-swap power supply” on page 133.
Installing a hot-swap power supply
The following tips describe the type of power supply that the server supports and other information that you
must consider when you install a power supply:
• For 460-watt power-supply server models, the standard shipping has only one 460-watt power supply
installed in the server. For redundancy and hot-swap support, you must install an additional 460-watt
hot-swap power supply. Certain customized models might be shipped with two power supplies installed.
• Make sure that the devices that you are installing are supported. For a list of supported optional devices
for the server, go to http://www.lenovo.com/ serverproven/.
1
2
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Chapter 7
.
Removing and installing server components
133