Group 9
Equipping/maintenance
Page 139
Release 3.00
Leibinger-Jet 2 se
9.3.4 Other servicing work
9.3.4.1 Adjusting the ink jet in the gutter
Dangerous electrical voltage!
Contact causes serious damage through an electric shock!
Disconnect the device from the mains supply prior to opening.
Remove mains plug!
Risk of fire!
Combustible gases and liquids cause serious burns. Sources of
ignition must be kept away from the print head!
Risk of injury!
Ink escapes from the head aperture. Spraying of ink into the eyes
can cause blindness. Eye protection is necessary!
This work must only be carried out by trained personnel or by
Leibinger service technicians!
If you use a new nozzle, it is necessary to readjust the ink jet. This can be carried out
with adjusting screws (cross head) located on the holder of the deflector unit by screwing
in or out (swivelling upwards or downwards or to the left or right) (see following
illustration). In order to achieve a better contrast in poor light it is helpful if you first of all
clean the gutter and the print head chassis with Leibinger solvent and hold white paper
behind or below the gutter. Further information on this subject area can be found in the
chapter
Cleaning
.
The adjustment of the ink jet must first of all be performed
vertically then horizontally!
The correct jet position can be seen from the following illustration!
The correct position of the ink jet must be checked in order to ensure that no deposits
develop in the gutter.
