Group 9
Equipping/maintenance
Page 137
Release 3.00
Leibinger-Jet 2 se
!
The LEIBINGER- JET 2 is without pressure and
must
be disconnected from the
mains supply.
Remove mains plug!
Figure 106
!
Undo the 2 Allan screws and remove the entire pressure tank if the tube connections
allow this (picture sequence 1).
!
Place the collection tub underneath the tank and remove both connections for the
viscosity regulation. The ink will run out. If necessary all hydraulic connections can
be removed.
!
Unscrew the 8
continuous
Allan screws that hold the pressure tank together (picture
sequence 2) and remove the lower half of the housing downwards.
The membrane
flange must not be loosened!
!
Pull off the filter and slide on the new filter (picture sequence 3).
!
Clean any possible dirt in the filter housing with thinner. Examine the O-ring for
damage and clean. If necessary replace.
Unscrew only the continuous allan screws!
4
5
1
2
3