IC-Module for EtherNet/IP
49 / 137
5.2 Configuration
This section describes how to configure the module and associated
components and applications.
NOTICE
Ø
The module has no undo function.
è
Changes are applied after a reset or start of the operating mode without
any further confirmation.
ð
If you want to reset all values, use the function "Reset to factory
settings". [
}
119] Please note that all previous settings made will be lost.
Configuration using the CDI
To configure the Module and put it into operation using the CDI, you
need a PC or notebook with a serial interface (RS-232) or USB/serial
adapter. Make sure that the adapter drivers are installed.
Communication with the CDI (Configuration and Debug Interface) of
the module takes place using a terminal program (e.g. PuTTY for
Microsoft Windows®).
To establish a connection to the module via CDI, you need the
following connection parameters:
– 115200 bit/s
– 8 data bits
– 1 stop bit
– even parity (Even)
The chapter "CDI" explains how to set up a connection. You will also find a detailed description of all CDI menus here.
TIPP!:
The CDI is suitable for configuration during the development
and for diagnostic purposes. To configure several modules
automatically, we recommend performing the settings with Modpoll.
You can find an introduction and example of this in the Appendix
Configuration via Modpoll [
}
136].
Commissioning
