Krone Comprima F 155 XC, Original Operating Instructions, Page: 177 / 278

Settings 17
Setting the brake force release when feeding wrapping material 17.7
Comprima F 155 XC
Original Operating Instructions 150001050_01_en 177
If "KRONE excellent" net or film is not used for the tying, the brake force may have to be
adjusted at the eyelet bolt (3).
ü The machine is shut down and safeguarded, refer to page 27 .
ü
The roll holder has been swivelled forwards.
„ To increase the brake force, increase the dimension X or hook the eyelet bolt (3) into the
upper cone (4), if necessary.
„
To reduce the brake force, reduce the dimension X.
17.7 Setting the brake force release when feeding wrapping material
1
3
2
4
RP000-019
Particularly when the chamber film wrapping is set, there is a risk that the film will overturn on
the film roll instead of being fed to the round bale. If this happens, the brake force release
should be adjusted for the feed process.
When the wrapping material is guided to the round bale, the brake force should be reduced so
that the wrapping material can be pulled more easily off the round bale.
This brake force release during the feed process can be set on the spring (3) on the right side of
the machine behind the side hood.
The more the spring (3) is tensioned, the greater the brake force release during the feed
process.
ü The actuator for wrapping process is in the feed position, refer to page 146 .
ü
The machine is shut down and safeguarded, refer to page 27 .
„ Check that the disc (2) is located above the spring (3) at the level of the central notch (4).
„
To change the tension of the spring (3), loosen or tighten the nut (1).
Notches (4) Spring tension (3) Wrapping material for the feed pro-
cess
top low The wrapping material can be pulled
with difficulty.
central medium The wrapping material can be pulled
with medium strength. KRONE re-
commends this setting as an op-
timum brake force release during the
feeding of the wrapping material.
bottom strong The wrapping material can be pulled
easily.