Krone Comprima F 155 XC, Original Operating Instructions, Page: 80 / 278

8 Operation
8.12 Pick-up
80
Comprima F 155 XC
Original Operating Instructions 150001050_01_en
ð
The key switches to .
„
To lift the pick-up into the transport position, actuate the control unit on the tractor (yellow,
3+).
8.12.2 Setting the pick-up working height
RPG000-151
The working height of the pick-up (3) must be set so that the distance between the tines and the
ground is approx.
20-30 mm . Also the working height of the pick-up (3) must be adjusted to the
ground conditions.
Make the following setting on the right and left sides of the pick-up in the same way:
„
Shut down and safeguard the machine, refer to page 27 .
„ Remove the linch pin (2).
„
Push the perforated bar (1) into the required position and secure with linch pin (2).
„ Lower the pick-up (3) hydraulically.
„
Shut down and safeguard the machine, refer to page 27 .
„
Check whether the distance between the tines and the ground is approx. 20-30 mm .
„
If required, re-adjust the perforated bar (1).
„
Check whether the drawbar height of the machine must be adjusted to the tractor, refer to
page 47 .
Setting the pick-up working height more precisely
1
3
I
II
III
2
RPG000-127
If ground conditions are extreme, the height of the pick-up can also be set via the chain (3). To
do this, the pick-up can be set higher or lower by one complete chain link or even more
precisely via the chain holder (1).