Krone Comprima F 155 XC, Original Operating Instructions, Page: 164 / 278

16 Driving and transport
16.1 Preparing the machine for road travel
164
Comprima F 155 XC
Original Operating Instructions 150001050_01_en
16.1 Preparing the machine for road travel
ü
The machine is completely and correctly hitched to the tractor, refer to page 53 .
ü The control units on the tractor are in neutral position and locked.
ü
The machine is shut down and safeguarded, refer to page 27 .
ü
All the guards are closed and locked.
ü The wheel chocks are secured in the supports / holders on the machine, refer to page 77 .
ü
The support jack is in the transport position, refer to page 73 .
ü
The road lighting has been connected, tested and is functioning properly, refer to page 67 .
ü The pick-up is fully raised in transport position, refer to page 79 .
ü The bale chamber is empty and the tailgate is closed.
ü
Soiling and crop residue have been removed from the machine, in particular from the
lighting and identification elements.
ü The tyres have no cuts and breaks.
ü
The tyre pressure is correct, refer to page 43 .
ü
The brake is functioning properly.
ü
For version with "Single axle with compressed air brake" or "Tandem axle with
compressed air brake"
: The brake force regulator has been set to full load (1/1), refer to
page 78 .
ü
The permitted maximum speed of the machine is known and is maintained.
ü The road travel screen is open, refer to page 126 .
16.2 Parking the machine
„
Before uncoupling the machine from the tractor, completely close the tailgate.
„
Shut down and safeguard the machine, refer to page 27 .
„ Bring the support jack in support position, refer to page 73 .
„
On the tractor side remove the safety chain from the universal shaft, disconnect the
universal shaft and place in the universal shaft chain.
„
When using a safety chain as an additional safety precaution for trailed implements:
Remove the safety chain.
„ Disconnect the road lighting plug, refer to page 67 .
„
Remove the power supply cable for the terminal.
„
Disconnect the hydraulic hose lines and hook them into the support at the machine.
„ Fit the safety device which prevents unauthorised use and keep the key in a safe place,
refer to page 78 .
„ Drive the tractor away carefully.
16.3 Securing the universal shaft
If the universal shaft is not connected to the tractor, it must be secured on the drawbar with the
universal shaft retaining chain or with the universal shaft bracket.