Commissioning
87
If the adjustment of the towing ring is not adequate, adjust the side parts (4).
To do this:
• Unscrew the screws (3)
• Adjust the height of the front parts of the drawbar (4) to the height of the tractor hitch
• Fit and tighten the screws (3)
Changing the drawbar hitch
The drawbar is set as standard as the bottom hitch (a). To set as top attachment (b), rotate both
front parts of the drawbar (4) by 180 degrees.
To do this:
• Unscrew the screws (3)
• Remove the front parts of the drawbar (4) and rotate by 180 degrees
• Using the screws (3), attach the turned front parts of the drawbar between the drawbar (5)
and tighten the screws
Pos: 77.22 /BA/War tungHinweis Anzi ehdrehmomente beachten (siehe Kapitel Wartung „ Anzi ehdr ehmomente“). @ 326\mod_1425977305778_78.docx @ 2502836 @ @ 1
Note
Observe tightening torques (refer to chapter Maintenance “Tightening Torques”).
Pos: 77.23 /BA/Erstinbetriebnahme/Groß packenpressen/H öhenanpassung des Antriebsstrangs @ 32\mod_1253688399975_78.docx @ 316233 @ 2 @ 1
8.4
Adjusting the height of the drive train
Fig. 47
The universally-jointed drive shaft (1) between the intermediate bearing (2) and the tractor
transfuses the power of the tractor to the intermediate bearing. In order to have an ideal power
transmission the articulation angle of the universally-jointed drive shaft must be as small as
possible in the range of the intermediate bearing. After adjusting the height of the drawbar
check the articulation angle of the universally-jointed drive shaft in the range of the intermediate
bearing, and if necessary adapt it.
To do this:
• Use an eligible auxiliary means in order to support the intermediate bearing during the
whole adjustment process
• Remove the screws (3) of the intermediate bearing
• Move intermediate bearing (2) in the hole pattern
• Assemble and tighten the screws (3)
Pos: 77.24 /Layout Module /---------------Seitenumbr uch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1