Settings
273
Pos: 93.81.6 /Ü berschriften/Ü berschriften 3/A-E/E/Einstell ung Gar nhalter @ 47\mod_1285054111875_78.docx @ 455539 @ 3 @ 1
19.13.5
Setting of twine retainer
Pos: 93.81.7 /BA/Ei nstellungen/Groß packenpresse/Knoter/D oppel knoter/Gar nhalter D oppel knoter Bil d 1290 HDP II @ 156\mod_1363880514392_78.docx @ 1379138 @ @ 1
a
Fig. 195
Pos: 93.81.8 /BA/Ei nstellungen/Groß packenpresse/Knoter/Gar nhalter T ext Ei nfachknoter / D oppel knoter R aspe @ 47\mod_1285053711171_78.docx @ 455513 @ @ 1
Setting the twine driver
The function of the twine driver (5) depends on the position of its indentation opposite the twine
disc cleaner (7). The twine driver (5) has been set to a = 0-2 mm as a default setting ex works.
• If the indentation on the twine driver (5) is positioned too far forward (clockwise), the
twine cannot be snagged by the twine driver as it is being guided along by the
needle.
• On the other hand, if the indentation on the twine driver (5) is positioned too far back
(anticlockwise), the twine strand may become wound up on the knotter hook or it
may not be possible for it to be snagged by the knotter tongue.
Setting the twine driver (5)
The indentation of the twine driver (5) has to be located at the position shown.
Then:
• Undo the nut (4) until the nut (4) is flush with the thread end of the auger
• Undo the auger by means of a slight knock against the nut (4)
• Adjust to a = 0-2 mm by turning the auger
• Tighten nut (4)
Note
At least two tying processes must be performed to check for the correct position of the
indentation.
Pos: 93.81.9 /Layout Module /---------------Seitenumbr uch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1