Terminal – menus [Medium Plus/Comfort Plus Electronics]
8
Alarm messages
8.16
Supplement to Operating Instructions 150000774_00 _en
BiG Pack 870 HDP, BiG Pack 870 HDP XC
89
Error number
Possible cause
Remedy
522060-7
The packer is blocked.
•
Stop the travelling gear
immediately.
•
Reduce the PTO speed until the
crop blockage has been
removed.
•
Set the sensor.
522061-7
OFF
Timeout for locking/releasing the self-
steering axle
•
Check the hydraulic connection.
•
Check the sensor and replace if
required.
522062-7
The pick-up is blocked.
•
Check the mechanism.
•
Remove the crop blockage.
522063-1
The pick-up speed is below the
minimum speed.
•
Set the sensor.
522064-7
The pick-up has not been raised in
road mode.
•
Raise the pick-up.
522065-7
The pick-up is not detected in road
mode.
•
Raise the pick-up.
522066-7
The twine boxes were moved from
the locked position without request.
•
Raise the twine boxes.
522067-7
The twine boxes are not in the locked
position and the cardan shaft is
active.
522068-7
The twine boxes are not in the locked
position when the machine starts.
522069-1
B57
The minimum speed for knotter
cleaning was not reached.
•
Increase the speed.
522071-7
S3
The "Move in residual bale ejector"
pushbutton is sticking.
•
Eliminate the cause of the
pushbutton sticking.
•
Replace the pushbutton.
522072-7
S4
The "Move out residual bale ejector"
pushbutton is sticking.
522073-12
Automatic mode is not possible
because the bale chute at top has
been lowered.
•
Lower the bale chute.