Krone 870 HDP, Original Operating Instructions, Page: 496 / 568

8 Terminal – menus [Medium Plus/Comfort Plus Electronics]
8.16 Alarm messages
90
Supplement to Operating Instructions 150000774_00 _en
BiG Pack 870 HDP, BiG Pack 870 HDP XC
Error number Possible cause Remedy
522078-15 The upper limit value of the moisture
measurement has been exceeded. • Check the setting and correct if
required.
522079-17 The lower limit value of the moisture
measurement has not been reached. • Check the setting and correct if
required.
522080-2
S7
The "Switch on blade cassette"
pushbutton is sticking. • Eliminate the cause of the
pushbutton sticking.
• Replace the pushbutton.
522081-2
S8
The "Switch off blade cassette"
pushbutton is sticking.
522085-13 The "Baling ram at rear" sensor is
defective. • Replace the sensor.
522086-13 The "Baling ram at front" sensor is
defective.
522087-17 The "Measure" sensor and the
"Calibrate" sensor have been
interchanged. • Swap the plugs of the "Measure"
and "Calibrate" sensors.
522088-7 "Packer feed (feeder strip)" sensor • Set the sensor.
8.16.1.6 Error message from sensors 522100 – 522299
All error messages from sensors are configured according to the following sample:
e.g. error message "522101-6
B 8
"
522101 6 B 8
SPN (Suspect Parameter Number) FMI Icon
Designation Explanation
SPN (Suspect Parameter Number) Error number
FMI Indicates the type of error, refer to page 80 .
Icon Meaning of the icons, refer to page 70
8.16.1.7 Error message from actuators 522300 – 522499
All error messages from actuators are configured according to the following sample:
e.g. error message "522301-6
K17
"