Keysight Technologies DSO-X 2014A, User Manual

Page: 5 / 378

Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide 5
An MSO lets you debug your mixed-signal designs using analog signals and
tightly correlated digital signals simultaneously. The 8 digital channels have a
1 GSa/s sample rate, with a 50 MHz toggle rate.
• 8.5 inch WVGA display.
• Interleaved 2 GSa/s or non-interleaved 1 GSa/s sample rate.
• 1 Mpts per channel MegaZoom IV acquisition memory for the fastest waveform
update rates, uncompromised.
• All knobs are pushable for making quick selections.
• Trigger types: edge, edge then edge, pulse width, pattern, OR, rise/fall time,
Nth edge burst, runt, setup & hold, video, and USB.
• Serial decode/trigger options for: CAN/LIN, I
2
C/SPI, and UART/RS232. There
is a Lister for displaying serial decode packets.
Digital channels and serial decode cannot be on at the same time. The
[Serial]
key takes precedence over the [Digital] key. Serial triggers can be used when
digital channels are on.
• Math waveforms: add, subtract, multiply, FFT, d/dt, integrate, square root,
Ax+B, square, absolute value, common logarithm, natural logarithm,
exponential, base 10 exponential, low pass filter, high pass filter, magnify,
measurement trend, chart logic bus timing, and chart logic bus state.
• Reference waveforms (2) for comparing with other channel or math waveforms.
• Many built-in measurements.
• Built-in license-enabled waveform generator with: sine, square, ramp, pulse,
DC, noise.
• USB ports make printing, saving and sharing data easy.
• Optional LAN/VGA module for connecting to a network and displaying the
screen on a different monitor.
• Optional GPIB module.
• A Quick Help system is built into the oscilloscope. Press and hold any key to
display Quick Help. Complete instructions for using the quick help system are
given in "Access the Built-In Quick Help" on page 45.
For more information about InfiniiVision oscilloscopes, see:
www.keysight.com/find/scope