Rev. 1.01 Technical changes reserved.
© Janich & Klass Computertechnik GmbH, Wuppertal, 2015
page 8-13
XINO
®
S700
Maintenance
Chapter
8
8.3.2.2
Replacing the coating of the separation roller
The separation rollers serve to separate the sheets prior to scanning. In order to
replace the roller coating of the separation roller, the separation roller needs to be
removed as described in chapter 8.3.1.4.3, page 8-9.
1.
Push the worn roller coating all around from the inside to the outside over the
lateral stop of the plastic roller. (This might require a little patience and fine
motor skills.)
2.
Strip the roller coating off the sides.
Fig. 8-19 Replacing the roller coating of the separation roller.
3.
Slide on new roller coatings.
4.
Make sure that the roller coating is positioned evenly inside the guide of the
roller.
5.
Then reinsert the separation roller unit as described in chapter 8.3.1.4.3,
page 8-9.
PLEASE
NOTE:
Only use the original roller coating from the manufacturer.
The grip of the separation roller coating is designed for normal paper.
There are alternative separation roller coatings for special requirements.
For further information in this regard please contact your service
technician.
