Chapter
Maintenance
XINO
®
S700
Rev. 1.01 Technical changes reserved.
page 8-16
© Janich & Klass Computertechnik GmbH, Wuppertal, 2015
8
8.3.4
Performing a white balance
In order to perform a white balance, please proceed as follows:
1.
Open the scanning area as described in chapter 7.2.1.1, page 7-3.
2.
Insert the sheet by means of which you want to carry out the white balance
into the scanning area. The sheet must have the same width as the scanning
area!
3.
Afterwards close the scanning area as described in chapter 7.2.1.1,
page 7-3.
4.
Press the
configuration
button .
5.
The configuration screen opens.
6.
Press the
white balance
button .
7.
The white balance screen opens.
8.
Set the parameters for the white balance.
If you are not sure as to which are the correct settings, please consult a
service technician!
Fig. 8-24
White balance
