J.A. Woollam M-2000, Hardware Manual

Page: 80 / 178

80 ©2023 J.A. Woollam Co. M-2000® Hardware Manual
2. Close the Alignment Screen. Select Hardware > Controls >
Misc >‘Additional Hardware Functions’ to open the Hardware Functions
window. Select “Show Alignment Camera Setup Dialog”. This shows
both the Z/Image Camera and the Tilt Camera.
Figure 4-51. Additional Hardware Functions- Show Alignment Camera Setup.
3. Select the ‘Z Align’ check box to verify the Z LED is working.
4. Select the ‘Tilt Align’ check box to verify the Tilt LED is working.
Note: For collimated beam (unfocused) measurements, the alignment spot
positions do not need to be centered.
5. If both alignment LEDs are ON, the alignment camera will function. Do
not make any hardware adjustments, only an offset calibration is needed.
If the image is out of focus and this is desired, see Chapter 7 for
adjustment instructions.
Figure 4-52. Tilt/Z Camera Alignment Utility window.
Z/Image Camera Tilt Camera
(may not be centered)