J.A. Woollam M-2000, Hardware Manual

Page: 103 / 178

M-2000® Hardware Manual ©2023 J.A. Woollam Co. 103
6 Focusing Optics
Note: This chapter pertains to removable focusing optics, which is an
optional accessory that may or may not have been purchased with
your instrument.
6.1 General Overview
Figure 6-1. Focusing probes.
The focusing optics consists of the Source and Receiver tilt stages and two
focusing lens mounts. The tilt stages are used to translate the position of each
lens that is mounted in the end of the cone shaped lens mounts. Each tilt stage
contains a fine adjustment screw for the vertical position (VS and VR) and the
horizontal position (HS and HR). The tilt stages are also equipped with a view
port to view the light beam on the Receiver unit aperture.
Related configuration parameters can be viewed by selecting Hardware > System
Information >‘Edit Hardware Config’. Under Focusing Option, the Windows
option should be enabled (= true) and set to “Measure Offsets in ST” (= true).
HS
VS
VR
HR