J.A. Woollam M-2000, Hardware Manual

Page: 135 / 178

M-2000® Hardware Manual ©2023 J.A. Woollam Co. 135
Figure 8-19. Field of View calibration procedure.
4. Follow the instructions at the top of the window: “
Mark a visible feature on
the image by clicking it with the mouse, then move the translator to position the
feature at a different (x,y) coordinate and click on the feature again.”
Use a
fine tip marker to “create” a feature if necessary. (See Figure 8-19)
5. Press OK when finished.
Note: If not performed correctly, or not sure, just press Cancel and start
again.
6. To test the feature, open the Translator Window by selecting
Hardware > Controls > System >‘Translator.’
Figure 8-20. Click ‘Translator’ to open Translator window.
The translator
step size may
be adjusted if
necessary
.
Left Mouse Click
here (on feature)
Left Mouse Click here
(same feature)