20
©2023 J.A. Woollam Co.
M-2000® Hardware Manual
Note:
When the fiber is first installed it needs to be oriented for maximum
light throughput. This is covered in Chapter 10 Scheduled
Maintenance.
Caution: Proper handling of the fiber is necessary to ensure long lifetime.
When removing the protective rubber end cap, hold the end cap
and pull the SMA connector nut. Do not pull directly on the fiber.
Never allow the fiber tip to contact any other surface (fingertip,
tabletop, etc.). Always cover the tips with protective rubber end
caps when the fiber is not in use. The bend radius of the fiber
should never be smaller than two inches. Never use a tool to
tighten the fiber - it should only be finger-tight.
Detector/Lamp Power Control Module
Figure 2-13. M-2000 Detector and Lamp Power Supply Module.
The M-2000 Detector and Lamp Power Supply Module contains a UV-VIS
Spectrometer covering a wavelength range of 193-1000 nm and an optional NIR
Spectrometer that covers a wavelength range of 1000-1690 nm. It also contains
highly regulated DC switching power supply for the Light Source. The switching
power supply provides a very stable source of power for the system lamp(s).
Electronics Control (EC) Module
Figure 2-14. Electronics Control Module.
The Electronics Control Module contains a 486DX2 embedded computer. This
computer is responsible for controlling the analog-to-digital (A/D) converter, the
stepper motor drivers, and communicating with the host computer via a network
card.
Summary of Contents for M-2000
