Platinum™ IP3
Installation and Operation Manual
Resource Module (PX-RES)
© 2016 Imagine Communications Corp.
Proprietary and Confidential.
September 2016 | Page 45
Communications Back Panel (PX-CBP)
The
PX-CBP
communications back panel provides an interface between communications connectors and
Resource Modules. All control ports remain inactive until, and only if, the router has fully booted and
has established communications.
Even in a powered-down state, a router connected to any communications system must not interfere
with that system, and therefore must not violate the communications standard (RS-232, RS-422, IEEE
802, etc.) when in this state.
A temperature sensor on the PX-CBP monitors the external ambient temperature.
Figure 14:
PX-CBP Communication Back Panel
The following connector types are available on the
PX-CBP
module:
Four Ethernet Ports (on page
Four Sync Ports (on page 47) with looping connectors
One Alarm Port (on page 48)
Two Serial Ports (on page 51)
Two XY Ports (on page 51) with loop through
One LTC Bi-Directional Port (on page 48)
