Platinum™ IP3
Installation and Operation Manual
Output Modules (PX-OB)
© 2016 Imagine Communications Corp.
Proprietary and Confidential.
September 2016 | Page 121
PX-HSR8O2DS-OBG Output Module
PX-HSR1D2D-OBG Output Module (on page 137)
Table 53:
PX-OB Output Options
Back Module Type
Number of Outputs
HD-BNC
Sixteen Electrical Outputs
SFP (optical)
Sixteen Optical Outputs
PX-OB Expansion
PX-OB
also provides a router expansion (8 input channels) interface using DensiShield.
See PX-HSR8C2DS-OBG Output Module and PX-HSR8O2DS-OBG Output Module.
Inserting Output Modules into the Platinum
IP3 frame
Each Output Module may be inserted into, or extracted from, a Platinum IP3 frame while the frame is
powered and functioning. The system Controller will recognize the addition or removal of an Output
Module from any of the Output Module slots, and will update the change automatically. When the
Controller recognizes the addition of an Output Module, it allows the user to control the additional
inputs to the matrix.
When inserted into the Platinum IP3 frame, each Output Module mates with a passive connector
assembly (back module), mounted in the rear of the frame. This assembly allows a high integrity
interconnect between the input cables and the input module, without requiring any active components.
Frames that are not fully populated with modules when shipped from the factory contain blank covers
over the non-populated slots. If an Output Module is added to the frame at a future time, the blank
cover must be replaced with the corresponding back module.
Note:
Platinum IP3 modules can be damaged if they are plugged into the wrong back modules or wrong
slot. Care should be exercised when plugging modules into the frame.
Failsafe Mode
To put an Output Module in Failsafe Mode:
1.
Unplug the board
2.
Set the Failsafe jumper.
3.
Wait 10 seconds
4.
Insert the board again
