Platinum™ IP3
Installation and Operation Manual
Audio TDM Crosspoint Module
(PX-ATDM64-X28)
© 2016 Imagine Communications Corp.
Proprietary and Confidential.
September 2016 | Page 91
Instructions to Replace the Fan Blowers
Using needle-nosed pliers, carefully lift the Fan Connector off the board, taking care not to twist or bend
it. Carefully remove the clip that the wire runs through.
1.
Remove the wire than runs through the clip.
2.
Remove the 2 Phillips mounting screws and gently lift the fan blower off the board.
3.
Replace the Fan blower.
4.
Attach the Fan Connector and wires.
Sync References
The ATDM module requires a
PT-SYNC
module to be installed in the frame for distribution of an
internal sync signal, which uses up the
SYNC4
distribution path.
SYNC1
and
SYNC2
are used for connecting Video References.
PX-ATDM64-X28 Block Diagram
Figure 33:
PX-ATDM64-X28 Block Diagram
Note that in case of a 15 RU frame, Slots 1-32 apply both on the Input and the Output side. For a 28 RU
frame, 64 slots apply on both sides.
Audio from each Input slot is routed to both ATDM Crosspoints and Outputs from the ATDM Crosspoints
are routed to each Output Slot. Both ATDM Crosspoint receive and process audio signals simultaneously.
