Idex Hale Sam, Technical Manual

Page: 91 / 223

71
C. If required, perform paragraph 6.1.3.1 (page 188) to update new valves
memory/parameters. (The information required to perform an update [using the
Device Select Menu procedure] was noted/recorded in paragraph 4.5.1
[page 67]).
D. Perform paragraph 6.2, Identifying Which Physical Valve A UID Corresponds To,
(page 187) to verify replacement valve contains correct programming/software.
E. Perform applicable subparagraph(s) of section 5, Adjustments, page 173.
See NOTES below.
NOTES
All replacement Akron Brass Swing-Out™ valves in a SAM system require the perfor-
mance of the Valve Position Procedures (see paragraph 5.2.1, page 173).
Additionally, Akron Brass Swing-Out™ valves (used for discharge purposes in a SAM
system) require the performance of the Pressure Procedures (see paragraph 5.2.2,
page 177) in addition to the Valve Position Procedures (referenced above).
If the replacement Akron Brass Swing-Out™ valve is optionally equipped with a flow-
meter, perform the Flowmeter Procedures (see paragraph 5.2.3, page 178).
4.5.3 Verifying Valve Operation After Valve Clocking
NOTE
All intake valves are clocked and tested by Hale and should NOT require clocking. If a
valves clocking is changed perform the following to ensure proper valve assembly after
clocking the valve.
Perform the following to verify post valve clocking reassembly operation of all disassembled Ak-
ron Brass swing-out discharge valves.
Refer to Table 25 for a list of tools and/or consumables required for this procedure.
Table 25. Akron Brass Valve Operation Verification Tools And Consumables List
Standard Tools Special Tools Consumables
PPE (Eye and Hand Protection) None Shop Rag(s) (As Required)
7/16-in Wrench Cable Ties (As Required)
A. Examine valve to determine ball portion of vales position.
DO NOT USE A DRIVER AND SOCKET TO INITIALLY MOVE A CLOCKED VALVE.
B. If ball is closed (or partially closed), open valve as follows. Otherwise go to Step C.
Using 7/16-in wrench, turn motor shaft CW.
Verify valve ball rotates CCW and fully opens.
DO NOT USE A DRIVER AND SOCKET TO INITIALLY MOVE A CLOCKED VALVE.
C. If ball is open (or partially open), close valve as follows.
Using 7/16-in wrench, turn motor shaft CCW.
Verify valve ball rotates CW and fully closes.