66
Refer to Table 23 for a list of tools and/or consumables required for this procedure.
Table 23. MIV Activation Button Tools And Consumables List
Standard Tools
Special Tools
Consumables
PPE (Eye and Hand Protection) None
Shop Rag(s) (As Required)
1-in Wrench
Cleaner
(See paragraph 4.1.3, page 44.)
Wire Cutter
Cable Ties (As Required)
Non Marring Hammer
MIV Activation Button
<See FSG-PL-01505, Sheet 2>
Punch
MIV Activation Placard
<See FSG-PL-01505, Sheet 2>
If an MIV activation button (activation switch or indicator) fails or the placard is damaged; replace
the assembly as follows.
Removal
A.
Open/remove MIV cover panel.
B.
Note cable tie locations, cut ONLY ties required to R&R MIV activation button.
C.
Tag and disconnect electrical connector from harness.
D.
At rear of switch, using 1-in wrench, remove nut.
E.
Remove switch.
NOTE
If the placard is NOT damaged, do NOT remove and replace the placard.
Placard Removal
A.
Open/remove MIV cover panel.
NOTE
The hole in the panel is larger than the hole in the placard.
B.
At rear of panel, place punch on rear of placard, strike punch with hammer to re-
move placard from panel.
C.
Clean and dry panel to remove all remaining adhesive. (See Table 23.)
Placard Installation
A.
Secure/support MIV cover panel.
B.
Remove protective paper from rear of placard.
NOTES
Do NOT let the placard touch the panel before proper alignment is achieved. (The plac-
ard is coated with a onetime use adhesive.)
The panel must be completely clean and dry before applying the new placard.
C.
Align (square and plumb) placard with panel edges and center placard hole over
panel hole.
D.
Press placard on to panel firmly.
E.
Open/remove MIV cover panel.
Summary of Contents for Hale Sam
