Idex Hale Sam, Technical Manual

Page: 173 / 223

153
Table 78. Hale SAM System Level SCR Table
SYMPTOM CAUSE REMEDY
AUXILIARY INTAKE LOST USE MANUAL
OVERRIDE
Wire Harness Discon-
nected/Damaged
Check harness power connections
and circuit breakers. See para-
graph 4.3.5 (page 48) and sec-
tion 4.10.6 (page 115).
Check harness Green CAN bus con-
nections. Refer to FSG-PL-01503/
FSG-PL-01504 and industry standard
Deutsch connector practices.
Check harness Green CAN bus re-
sistance. See paragraph 4.16.3
(page 170).
Equipment Failure R&R failed AB valve. See section 4.5
(page 67).
Ponys address incorrect. See Table 1
(page 26) and if required contact
Hale Customer Service (800-533-
3569) for instructions.
CAFS COMM LOSS, USE SMARTCAFS
DISPLAY
CAFS Module Power Is Off Power cycle the CAFS module and
confirm the module lights are active.
Refer to FSG-MNL-00157 CAFS man-
ual.
Wire Harness Discon-
nected/Damaged.
Check wiring continuity. Refer to
FSG-PL-01503/FSG-PL-01504 and
industry standard Deutsch connector
practices.
Equipment Failure Failed SmartCAFS display. Refer to
UV SmartCAFS Installation and Oper-
ation Manual (FSG-MNL-00157).
Failed Foam Controller. Refer to UV
SmartCAFS Installation and Opera-
tion Manual (FSG-MNL-00157).
CHECK WATER SUPPLY
(Similar to WARNING LOW INTAKE
PRESSURE)
SAM reported not receiv-
ing enough water flow
from off-board water
source
See LOW INTAKE PRESSURE remedy.
Check suction strainers/hoses for
blockage and/or leaks.
COOLANT TEMPERATURE HIGH
CRITICAL
Pass Thru Message From
Apparatus ECU
Refer to apparatus/chassis/engine
manuals/documentation.
Pass Thru Message From
Apparatus ECU
Refer to apparatus/chassis/engine
manuals/documentation.
DISCHARGE COMM ERROR
(Command Sent, No Valve Response)
Valve Requires Service Ball/gears could be jammed. See
section 4.5 (page 67).
Equipment Failure R&R failed discharge valve. See sec-
tion 4.5 (page 67).