Idex Hale Sam, Technical Manual

Page: 121 / 223

101
Table 54. MIV–A Drive Module Wiring (From/To Listing)
Module Pin (From) MIV/Harness Pin (To)
1 (Power) [Input] System Power Refer to FSG-PL-01507
2 (CAN High) [Buss] Green CAN Bus Connector
3 (Motor A) [Output] A (MIV Motor)
4 (Motor B) [Output] B (MIV Motor)
5 (Open Indicator) [Output] 6 (MIV–Rocker Switch) See Table 20
6 (Air Bleed) [Output] C (ABV Solenoid) See Table 58
7 (Close Indicator) [Output] 4 (MIV–Rocker Switch) See Table 20
8 (Closed Stop Switch) [Input] A (Closed Stop Switch)
9 (Open Stop Switch) [Input] A (Open Stop Switch)
10 (Direction) [Input] 2 (MIV–Rocker Switch) See Table 20
11 (CAN Low) [Buss] Green CAN Bus Connector
12 (Ground) [Input] System Ground (Pump Body)
Refer to Table 55 for a list of tools and/or consumables required for this procedure.
Table 55. MIV–A Drive Module Tools And Consumables List
Standard Tools Special Tools Consumables
PPE (Eye and Hand Protection) None Shop Rag(s) (As Required)
Wire Cutter Cable Ties (As Required)
#2 Phillips Screwdriver MIV Control Module
<See FSG-PL-01491, Sheet 3>
NOTE: The MIV Control Module has multiple names: MIV Control, MIV Valve Drive, or
MIV 2.0 Drive Module.)
If the module fails or is damaged; replace the module as follows.
Removal
A.
Note cable tie locations, cut ONLY ties required to R&R module.
B. Tag and disconnect electrical connector.
C. Using #2 Phillips screwdriver, remove two [2] pan head 8-32 x 1.5-in long stain-
less screws (each with one lock washer).
D. Remove module.
Installation
A.
Align new module with MIV adapter.
B. Hand start two [2] pan head 8-32 x 1.5-in long stainless screws (each with one
lock washer).
C. Using #2 Phillips screwdriver, tighten screws.
D. Connect electrical connectors according to tags.
E. Install cable ties cut to R&R module as noted.