Idex Hale Sam, Technical Manual

Page: 116 / 223

96
Table 50. Sensor Module Wiring (From/To Listing)
Module Connector/Pin (From) Sensor Connector/Pin (To)
A Keyed Connector (Mates with Grey Harness Connector)
1 (GB Oil Level Signal) [Input] Gearbox Oil Level
2 (CAN High) [Buss] Green CAN Bus Connector
3 (CAN Shield) [Buss] Green CAN Bus Connector
4 (Auxiliary Input 1) [Input] N/C
5 (Auxiliary Input 2) [Input] N/C
6 (Pump Drain) [Output] C (Water Column Pressure Sensor) (See Table 31)
7 (Autolube) [Output] C (Zero Pressure Solenoid Negative) (See Table 44)
8 (Quick Prime) [Output] C (Quick-Prime Solenoid Negative)
9 (Auxiliary Output 1) [Output] N/C
10 (Pump Cool) [Output] C (Pump Cool Solenoid) (See Table 61.)
11 (CAN Low) [Buss] Green CAN Bus Connector
12 (Ground) [Input] System Ground
B Keyed Connector (Mates with Black Harness Connector)
1 (Anode 1) [Input] Anode 1 Lead (See Table 46)
2 (Anode 2) [Input] Anode 2 Lead (See Table 46)
3 (Anode 3) [Input] Anode 3 Lead (See Table 46)
4 (Gear Water In Oil) [Input] C (Gearbox Water In Oil Sensor) (See Table 40)
5 (Primer Input) [Input] Primer Input
6 (Auxiliary Input 3) [Input] N/C
7 (+5 Reference) [Output] C (Bar5 Reference) (See Table 26)
8 (Barometer Gnd Ref) [Output] A (Barometer System Ground) (See Table 26)
9 (Autolube Water In Oil) [Input] C (Autolube Water in Oil) (See Table 41)
10 (Barometer) [Input] B (Barometer Signal) (See Table 26)
11 (GB Oil Temperature) [Input] A (Temp Sensor in GB) (See Table 35)
12 (Suction Water Temperature) [Input] A (Temp Sensor in Pump Body) (See Table 38)
NOTE: The POWER screw between the A and B connectors connects to circuit breaker box
connector 1 pin 3.