Idex Hale Sam, Technical Manual

Page: 137 / 223

117
Refer to Table 68 for a list of tools and/or consumables required for this procedure.
Table 68. Circuit Breaker Box Tools And Consumables List
Standard Tools Special Tools Consumables
PPE (Eye and Hand Protection) None Heavy Duty Cable Ties (As Required)
Wire Cutter Circuit Breaker Box <See FSG-PL-01501, or
-01502, Sheet 3 or FSG-PL-01513, Sheet 5>
#2 Phillips Screwdriver
(Magnetic Tip, Optional)
Circuit Breaker (15 Amp)
<See FSG-PL-01507>
1/4-in Wrench Circuit Breaker (30 Amp)
<See FSG-PL-01507>
Plyers (or Fuse Puller) Grease or Bees Wax (Optional)
If the circuit breaker box fails or is damaged; replace the circuit breaker box as follows.
Removal
A.
Disconnect/turn off apparatus power to SAM circuit breaker box.
B. Note cable tie locations, cut ONLY ties required to R&R circuit breaker box.
C. Tag and disconnect all circuit breaker box electrical connectors and wires.
D. Using #2 Phillips screwdriver, remove four [4] cover screws. See Figure 85.
E. Remove cover.
F. Using 1/4-in wrench, hold nylon lock nut on rear of circuit breaker box mounting
bracket securing screw selected for removal.
G. Using #2 Phillips screwdriver, remove four [4] 6–32 X 1/2-in mounting screws.
(Screws are recessed deeply in each corner of the box.)
(Use the 1/4-in wrench to hold the lock nut for each screw while removing it.)
H. Remove circuit breaker box from bracket.
Installation
A.
Using #2 Phillips screwdriver, remove four [4] cover screws. See Figure 85.
B. Remove cover.
C. If installing existing circuit breakers, ensure each circuit breaker is checked prior
to installation. (See paragraph 4.10.6.2, page 120.)
D. Install one [1] 15 Amp circuit breaker in position 1. (Refer to FSG-PL-01507.)
E. Install a 30 Amp circuit breaker in positions 2 thru 12.
(Refer to FSG-PL-01507, 11 circuit breakers required.)
F. Install new circuit breaker box on mounting bracket as follows.
NOTE
If desired, use optional magnetic tip, grease, or bees wax to stick one of the screws to
the tip of the screwdriver. Align the box to the mounting bracket and insert the screw
thru the box and bracket. Place new locking nut against screw and start screw into nut,
do NOT tighten. Repeat to install the other three screws and nuts. Tighten all screws.