Idex Hale Sam, Technical Manual

Page: 109 / 223

89
NOTE
Do NOT overtighten solenoid.
C. Hand tighten solenoid until snug.
D. Using slip joint plyers, torque an additional 1 turn (2 turns maximum) past hand
tight engagement.
E. Install solenoid on nipple.
F. Perform installation portion of Autolube assembly R&R. Reference Midship Pump
Technical Manual (FSG-MNL-00200).
G. Perform installation portion of circuit breaker box R&R procedure.
H. At top of Autolube assembly, install both module mounting brackets.
I. At modules, circuit breaker box, sensor, and solenoid, connect electric connect-
ors according to tags.
J. Install cable ties cut to R&R sensor as noted.
K. Pressurize system to check for leaks.
4.7.7 Smart Anode Removal And Replacement
The smart anode (Figure 61) protect the pump from electrolysis and corrosion. Q series pumps
typically utilize three [3] anodes (refer to FSG-PL-01501 or FSG-PL-01502 Sheet 8) while other
midship pumps (and booster) pumps (refer to FSG-PL-01513 Sheet 8) utilize one [1] anode (in-
stalled in the pump) and two [2] additional anodes (installed in the manifold).
Figure 61. Smart Anode
Table 46 provides the anodes electrical connections.
Table 46. Smart Anode Wiring (From/To Listing)
From To Sensor Module, Connector B, Pin To Pump
Anode Cable 1 ANODE 1 [Input] N/C
2 ANODE 2 [Input]
3 ANODE 3 [Input]
Ground Screw N/C Any Near By Ground Point